First of all, as a kind of industrial air cooler, the industrial centrifugal fans perform the acting on rotating disks and aerosol sprayers, and use centrifugal force to produce ultra-small droplets, which greatly increase the evaporation surface area. Due to the fact that the droplets flow through a powerful fan, it greatly increases the surface velocity of the liquid and accelerates the diffusion of gas molecules. Therefore, the evaporation of water is greatly increased. Water absorbs heat in the process of evaporation and reduces the temperature. At the same time, it can increase the relative humidity of the air, reduce dust and purify the air. Concerning about all of these factors mentioned above, the industrial centrifugal fans can be installed in metalworking workshop, machinery workshop, textile workshop and clothing workshop and so on, which can be used to cool down the temperature and remove the dust, and also can be used to eliminate static interference.
Second of all, industrial air cooler should be carefully checked before installation whether the industrial air cooler is intact, whether the fastener bolts are loose or off, and whether the impeller has a collision wind cover. Besides, carefully check whether the fan or shutter is deformed or damaged during the transportation. When installing and selecting the air outlet environment, we should pay attention to that there should be no too big obstacles within 2.5-3 m from the air outlet. When the industrial air cooler is installed, attention should be paid to the horizontal position of the industrial air cooler by adjusting to the foundation level. After installation of the motor of the industrial air cooler, you must check if there is any tilt phenomenon. When installing the industrial air cooler, the adjusting bolt of the motor should be in a convenient position, and the belt should be loosened when it is convenient to use. When installing the industrial air cooler support, it is necessary to make the support level stable with the foundation. If necessary, angle iron should be installed next to the industrial air cooler for reinforcements. After installation of the industrial air cooler, it is necessary to check its surrounding sealing. If there is a gap, you can seal it with the glass glue.